Which instruction is commonly required on drawings for SOG regarding reinforcing steel at joints?

Which instruction is commonly required on drawings for SOG regarding reinforcing steel at joints?

• A. Reinforcing steel must be discontinued (cut) so it doesn't pass through the joint, and every other bar or wire must be discontinued (cut) so only half passes through the joint.
• B. Reinforcing steel must be extended through the joint.
• C. No cutting of reinforcement is required near joints.
• D. Reinforcing steel should be bent to pass through the joint.

Answer: (A)

Joints in a slab-on-grade are meant to let panels move and crack control occur locally rather than across the whole slab. Because of that, reinforcement should not bridge the joint. Drawing notes often require discontinuing the bars at the joint and, to keep some small amount of restraint, cutting every other bar so only half of them cross the joint. This setup allows the joint to move with shrinkage and temperature changes while still providing crack control near the panel edges. Extending reinforcement through the joint would restrain movement and encourage undesirable cracking; not cutting reinforcement would remove the movement allowance the joint needs; bending bars to pass through the joint is not a standard practice and can complicate detailing.

Joints in a slab-on-grade are meant to let panels move and crack control occur locally rather than across the whole slab. Because of that, reinforcement should not bridge the joint. Drawing notes often require discontinuing the bars at the joint and, to keep some small amount of restraint, cutting every other bar so only half of them cross the joint. This setup allows the joint to move with shrinkage and temperature changes while still providing crack control near the panel edges.

Extending reinforcement through the joint would restrain movement and encourage undesirable cracking; not cutting reinforcement would remove the movement allowance the joint needs; bending bars to pass through the joint is not a standard practice and can complicate detailing.